![]() ![]() M0 (MSG, Click Continue to turn your spindle on at 1000 RPM) It will still load and run on the OneFinity just fine. Do not use a word processor because it will insert formatting commands that will cause errors. Copy the following g-code and paste it in a new Text File using Windows Notepad or equivalent. It will also demonstrate the use of M0 command with popup messages. OK, here is some g-code that will test your spindle and vfd to make sure they are working correctly with the OneFinity Controller. The information below should be a good way to test your vfd/spindle with the OneFinity Controller. I do have one on another cnc controlled by Mach3. I currently do not have a vfd/spindle on my OneFinity. Typical Breakout Board is 0-5V I believe the OneFinity output is 0-3.2 volts.| |PD070|0|Analog Input (Spindle PWM) Gecko G540 is 0-10V. Higher values decrease noise and increases heat) Adjust value if you get errors when Spindle starts.| Lower value increased noise and decreases heat. ![]() |PD041|8|Carrier Frequency (Affects the amount of RF noise. Be sure to use the ratings printed on the side of your actual spindle. These are the Settings for a 2.2KW water cooled spindle 110 vac Huanyang VFD Your settings may differ especially PD142 and PD 070. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |